How to paste Glass Mat

The pasting of Glass Mat requires a dedicated person to prepare polymer mortar to ensure the mixing quality. Turn the lid of the bucket counterclockwise to open it, and use a stirrer or other tools to re-stir the adhesive to avoid separation of the adhesive. Stir appropriately to avoid quality problems.

The mixing ratio of polymer mortar is: KL binder: 425# sulphoaluminate cement: sand base. Weigh the cement and sand in a measuring bucket and pour them into the iron ash tank for mixing. After stirring evenly, add the binder according to the mix ratio and stir evenly to avoid segregation and a porridge-like appearance. Water can be added appropriately according to the workability. Water is used for concrete.
Polymer mortar should be prepared as needed, and the prepared polymer mortar should be used up within 1 hour. Polymer mortar should be placed in a cool place to avoid sunlight exposure. Cut the Fiber Glass from the entire roll of Fiber Glass according to the pre-required length and width, leaving the necessary overlap length or overlap length. Cut it in a clean and flat place, cut it accurately, roll up the cut Fiber Glass, and do not allow folding or stepping on it.
The Glass Mat should be used as a reinforcement layer at the sun corner of the building. The reinforcement layer should be attached to the inside, 150mm on each side. When applying polymer mortar, keep the EPS board surface dry and remove harmful substances or impurities from the board cotton.
Scrape a layer of polymer mortar on the surface of the polystyrene board. The scraped area should be slightly larger than the length or width of the Fiber Glass, and the thickness should be approximately 2mm. Unless there is an edge requirement, polymer mortar is not allowed to be applied on the polystyrene board. Board sides. After scraping the polymer mortar, the Fiber Glass should be placed on it. The curved surface of the Fiber Glass faces the wall. Apply smooth paint from the center to the surroundings so that the Fiber Glass is embedded in the polymer mortar. The Fiber Glass should not be wrinkled until the surface Once dry, apply a layer of polymer over it.