How to install the Profile Pvc so that it won't fall off easily?

Today, I will share my experience with you. It is necessary to have a dedicated person in charge of making polymer mortar to ensure the mixing quality. Turn the lid of the bucket counterclockwise to open it, and remix the binder with a mixer or other tools to prevent the binder from separating. Mix moderately to avoid quality problems.

Cut in a clean and flat place, and the material must be cut accurately. The cut corner beam must be rolled up, and folding and trampling are not allowed. Make a reinforcement layer at the corner of the building. The reinforcement layer should be attached to the inside, 150mm on each side. When applying the first coat of polymer mortar, the EPS board surface should be kept dry and harmful substances or impurities in the board cotton should be removed.

At the four corners of the door and window, after the standard corner beam is applied, a 200mmx300mm standard Corner beat is added to the four corners of the door and window, placed at a 90-degree angle to the bisector of the window angle, and pasted on the outside for reinforcement; a 200mm long corner beat with a width suitable for the window width is added to the inner corner and pasted on the outside.

Below the first window sill, in order to avoid damage caused by impact, the reinforced Profile Pvc should be installed first, and then the standard eifs corner should be installed. The editor reinforced eifs corner should be connected. The protective layer cannot be exposed to rain within 4 hours after construction. After the protective layer is finally set, it should be sprayed with water for maintenance in time, and it should not be less than 48 hours when the night average temperature is higher than 15℃, and it should not be less than 72 hours when it is lower than 15℃.