What to do with Glass Mat after work

Glass Mat is made of Fiber Glass as the base material, which is soaked and coated with polymer anti-emulsion. As a result, it has good alkali resistance, flexibility and high tensile strength in the longitudinal and latitudinal directions, and can be widely used for thermal insulation, waterproofing, crack resistance, etc. of interior and exterior walls of buildings.

Glass Mat is mainly made of Glass Mat, which is made of medium-alkali-free Glass Fiber yarn (twisted with a special organizational structure-leno tissue), and then treated with high-temperature heat setting such as alkali resistance and reinforcing agents. Glass Mat Mainly used in wall reinforcement materials, such as Glass Mat, GRC wall panels, EPS internal and external wall insulation boards, gypsum boards, waterproof membranes, asphalt roof waterproofing, fireproof boards, construction caulking tapes, etc.
The Glass Mat is placed at the four corners of the door and window. After the standard Fiber Glass is applied, a piece of 200mm×300mm standard Fiber Glass is added to the four corners of the door and window. It is placed at an angle of 90 degrees to the bisector of the window corner and attached to the outside for reinforcement; Add a piece of Fiber Glass 200mm long and suitable for the standard width next to the window at the inner corner, and attach it to the outside.
Below the first floor window sill, in order to prevent damage caused by impact, the Glass Mat should be installed first, and then the standard Glass Mat should be installed. The construction method of installing the reinforcement layer is the same as that of the standard Glass Mat. The Glass Mat pasted on the wall should be covered with the folded Glass Mat. The Glass Mat is applied from top to bottom. During simultaneous construction, the reinforced Glass Mat is applied first, and then the standard Glass Mat is applied.
After the Glass Mat is glued, it should be prevented from being washed away or hit by rain. Protective measures should be taken for the sun corners, doors and windows that are prone to collision, and anti-pollution measures should be taken for the feeding port. If surface damage or pollution occurs, it should be dealt with immediately. The protective layer cannot be exposed to rain within 4 hours after construction. After the protective layer is finally set, spray water for maintenance in a timely manner. When the average day and night temperature is higher than 15°C, it shall not be less than 48 hours, and when the average temperature of day and night is lower than 15°C, it shall not be less than 72 hours.