Introduce the method of pasting Fiberglass Cloth

The pasting of the Fiberglass Cloth requires a dedicated person to prepare the polymer mortar to ensure the mixing quality.

Open the lid of the bucket by rotating it counterclockwise, and use a stirrer or other tools to re-stir the adhesive to avoid separation of the adhesive. Stir appropriately to avoid quality problems. The mixing ratio of polymer mortar is: KL adhesive: 425# sulphoaluminate cement: sand bottom.
Weigh the cement and sand in a measuring bucket and pour them into the iron ash tank for mixing. After stirring evenly, add the binder according to the mix ratio and stir evenly to avoid segregation and a porridge-like appearance. Water can be added appropriately according to the workability. Water is used for concrete. Polymer mortar should be prepared as needed, and the prepared polymer mortar should be used up within 1 hour.
Polymer mortar should be placed in a cool place to avoid sunlight exposure. Cut the Fiber Glass from the entire roll of fiberglass Fiber Glass according to the pre-required length and width, leaving the necessary overlap length or overlap length. Cut it in a clean and flat place, cut it accurately, roll up the cut Fiberglass Cloth, and do not allow folding or stepping on it.
The Fiberglass Cloth should be used as a reinforcing layer at the sun corner of the building. The reinforcing layer should be attached to the inside, 150mm on each side. When applying polymer mortar, the EPS board surface should be kept dry to remove harmful substances or impurities in the board cotton.
Scrape a layer of polymer mortar on the surface of the polystyrene board. The scraped area should be slightly larger than the length or width of the Fiberglass Cloth, and the thickness should be approximately 2mm. Unless there is an edge requirement, polymer mortar is not allowed to be applied on the polystyrene board. Benzene board side.
After scraping the polymer mortar, the grid should be placed on it, with the curved side of the grid facing the wall, and smooth application from the center to the surroundings so that the grid is embedded in the polymer mortar. The grid should not be wrinkled. Fold it, wait for the surface to dry, and then apply a layer of polymer on it.