How to make the Profile Pvc stick to the wall better?

Except for those who have just entered the industry and are not very familiar with the industry, most people who do construction projects basically know that pvc Beads is used to be placed on the wall. It is placed on the wall for better advertising on the walls of high-rise buildings. However, many Profile Pvc will fall off soon after being glued to the wall, just like some tapes are not very reliable. So how to make the Profile Pvc stick to the wall better?

1. The person responsible for the preparation of polymer mortar must ensure the mixing quality. The Profile Pvc is woven with medium-alkali or alkali-free Glass Fiber yarn and coated with alkali-resistant polymer emulsion. The application of the Profile Pvc is more linked to the advertising industry, and the places involved are basically used for advertising on the walls of high-rise buildings. Profile Pvc manufacturer wall reinforcement material. The pvc Beads is based on glass fiber woven fabric and is soaked in polymer anti-emulsion coating. It has good alkali resistance, flexibility and high tensile strength in warp and weft directions, and can be widely used in building internal and external wall insulation, waterproofing, fire prevention, crack resistance, etc. Open the lid and rotate it counterclockwise, and re-stir the adhesive with a mixer or other tools. The adhesive will appear to avoid separation, and stir moderately to avoid quality problems.

2. It can be cut in a clean and flat place. The material cutting problem must be accurate. The cut edge bead must be rolled up, and folding is not allowed, and stepping is not allowed. Make a reinforcement layer at the corner of the building, and the reinforcement layer should be attached to the innermost side, 150mm on each side. When the first coat of polymer composite mortar is applied, the EPS board surface should be kept dry to remove harmful chemicals or impurities in the board cotton.

3. After using the standard screen, place a 200mm and 300mm standard screen at the four corners of the door and window, at a 90-degree angle to the bisector of the window angle, and stick it to the outermost side for reinforcement. Place a 200mm long screen at the outermost side of the sunshade angle and the standard width of the screen, and stick it to the outermost side. Under the first window sill, in order to prevent damage caused by impact, the reinforced arch bead should be installed first, and then the standard Profile Pvc. Reinforce the edge bead. Participate.

4. The protective layer should not be exposed to rain within 4 hours after construction. After the protective layer is finally set, it should be sprayed with water for maintenance in time. When the average maximum temperature during the day and night is obviously higher than 15℃, it should not be used for less than 48 hours, and when it is lower than 15℃, it should not be used for less than 72 hours.