How to make Drywall Tape stick better

How is the Drywall Tape bonded to the wall? How can the bonding quality be good and the Drywall Tape be less likely to fall off? The Drywall Tape manufacturer will share with us and hope that we can help. The production of polymer mortar must be done by dedicated personnel to ensure the mixing quality. Rotate the lid counterclockwise and open it, and use a mixer or other tools to remix the binder to avoid separation of the binder. Mix properly to avoid quality problems.

Cut in a clean and flat place. The cutting must be accurate. The cut Fiber Glass must be rolled up. Folding and trampling are not allowed. Make a reinforcement layer at the sun corner of the building. The reinforcement layer of the Drywall Tape manufacturer should be attached to the inner side, 150mm on each side. When applying polymer mortar over the entire surface, the EPS board surface should be kept dry to remove harmful substances or impurities from the board wool.
At the four corners of the door and window, after the standard net is applied, add a piece of 200mmx300mm standard net on the four corners of the door and window, place it at an angle of 90 degrees to the bisector of the window corner, and stick it to the outside for reinforcement; at the inner corner Add a piece of Fiber Glass 200mm long and suitable for the width of the window, and stick it on the outside.
Below the first floor window sill, in order to avoid damage caused by impact, the reinforced Fiber Glass should be installed first, and then the standard Fiber Glass should be installed. Drywall Tape manufacturers strengthen Drywall Tape matching. The protective layer cannot be exposed to rain within 4 hours after construction. After the protective layer is finally set, spray water for maintenance in a timely manner. When the average night temperature is higher than 15°C, it shall not be less than 48 hours, and when the average night temperature is lower than 15°C, it shall not be less than 72 hours.