Do you know what methods are available for pasting Glass Mat?

Building insulation material Glass Mat is based on Fiber Glass and soaked in polymer anti-emulsion coating. As a result, it has good alkali resistance, flexibility and high tensile strength in the longitudinal and latitudinal directions, and can be widely used for thermal insulation, waterproofing, crack resistance, etc. of interior and exterior walls of buildings. The Glass Mat is mainly alkali-resistant Glass Fiber Glass Mat. It is made of medium-alkali-free glass fiber yarn (the main component is silicate and has good chemical stability) and is twisted and woven with a special organizational structure-leno tissue. After high-temperature heat setting treatment such as alkali resistance and enhancer.

1. A dedicated person is responsible for preparing polymer mortar to ensure the mixing quality.
2. Open the lid by rotating it counterclockwise, and use a stirrer or other tools to re-stir the adhesive to avoid separation of the adhesive. Stir appropriately to avoid quality problems.
3. The mixing ratio of polymer mortar is: KL binder: 425# sulfoaluminate cement: sand (use 18 Fiber Glass sieve bottom): = 1: 1.88: 3.25 (weight ratio).
4. Weigh the cement and sand in a measuring bucket and pour them into the iron ash tank for mixing. After stirring evenly, add the binder according to the mixing ratio and stir evenly to avoid segregation and a porridge-like appearance. Water can be added appropriately according to the workability. Water is used for concrete.
5. Polymer mortar should be prepared as needed, and the prepared polymer mortar should be used up within 1 hour. Polymer mortar should be placed in a cool place to avoid sunlight exposure. Make a reinforcement layer at the sun corner of the building. The reinforcement layer should be attached to the inside, 150mm on each side.
6. Cut the Fiber Glass from the entire roll of Fiber Glass according to the required length and width, leaving the necessary overlap length or overlap length. Cut it in a clean and flat place, cut the material accurately, roll up the cut Glass Mat, and do not allow folding or stepping on it.
7. When applying polymer mortar, the EPS board surface should be kept dry to remove harmful substances or impurities in the board cotton. Scrape a layer of polymer mortar on the surface of the polystyrene board. The scraped area should be slightly larger than the length or width of the Glass Mat, and the thickness should be about 2mm. Except for those with edge wrapping requirements, polymer mortar is not allowed to be applied on the polystyrene board. Benzene board side.
8. After scraping the polymer mortar, the grid should be arranged on it. The curved surface of the grid cloth faces the wall. Apply smooth paint from the center to the surroundings so that the grid cloth is embedded in the polymer mortar and the grid cloth is not It should be creased and after the surface is dry, apply a layer of polymer over it.