Do you know the construction method of Fiberglass Cloth?

Open the lid of the bucket by rotating it counterclockwise, and use a stirrer or other tools to re-stir the adhesive to avoid separation of the adhesive. Stir appropriately to avoid quality problems. The polymer mortar mix ratio is: KL binder: 425# sulfoaluminate cement: sand (use 18 Fiber Glass sieve bottom): =1:1.88:3.25 (weight ratio). Weigh the cement and sand in a measuring bucket and pour them into the iron ash tank for mixing. After stirring evenly, add the binder according to the mix ratio and stir. The stirring should be even to avoid segregation and a porridge-like appearance. Water can be added appropriately according to the workability.

Water is used for concrete. Polymer mortar should be prepared as needed, and the prepared polymer mortar should be used up within 1 hour. Polymer mortar should be placed in a cool place to avoid sunlight exposure. Cut the Fiber Glass from the entire roll of fiberglass Fiber Glass according to the pre-required length and width, leaving the necessary overlap length or overlap length. Cut in a clean and flat place, cut the material accurately, and roll up the cut Fiber Glass. Folding and stepping are not allowed. Make a reinforcement layer at the sun corner of the building. The reinforcement layer should be attached to the inside, 150mm on each side.
When the Fiberglass Cloth manufacturer applies polymer mortar, the EPS board surface should be kept dry to remove harmful substances or impurities in the board cotton. Scrape a layer of polymer mortar on the surface of the polystyrene board. The scraped area should be slightly larger than the length or width of the Fiberglass Cloth, and the thickness should be approximately 2mm. Unless there is an edge requirement, polymer mortar is not allowed to be applied on the polystyrene board. Benzene board side.
After scraping the polymer mortar, the grid should be placed on it, with the curved side of the grid facing the wall, and smooth application from the center to the surroundings so that the grid is embedded in the polymer mortar. The grid should not be wrinkled. Fold it, wait for the surface to dry, and then apply a layer of polymer mortar on it with a thickness of 1.0mm. The Fiberglass Cloth should not be exposed. The overlapping length around the Fiberglass Cloth shall not be less than 70mm. At the cut parts, Fiber Glass patching shall be used for overlapping, and the overlapping length shall not be less than 70mm.
A reinforcing layer should be made around the doors and windows, and the Fiberglass Cloth of the reinforcing layer should be affixed to the inside. If the distance between the outer skin of the door and window frame and the surface of the base wall is greater than 50mm, the Fiberglass Cloth should be affixed to the base wall. If it is less than 50mm, it needs to be turned over. The Fiberglass Cloth laid on the large wall should be embedded in the outside of the door and window frame and glued firmly.