How to install the Profile Pvc so that it will not fall off easily

How to make the bonding quality good and the Profile Pvc will not fall off easily? Today, the Corner Angle manufacturer will share the hope with us. It is necessary to have a dedicated person in charge of making polymer mortar to ensure the mixing quality. Turn the barrel cover counterclockwise to open it, and remix the binder with a mixer or other tools to prevent the adhesive from separating. Mix moderately to avoid quality problems.

Cut in a clean and flat place, and the cutting must be accurate. The cut Corner Angle must be rolled up, and folding and trampling are not allowed. Make a reinforcement layer at the corner of the building. The reinforcement layer of the Bead Plaster manufacturer should be attached to the innermost side, 150mm on each side. When applying the first coat of polymer mortar, the EPS board surface should be kept dry and harmful substances or impurities in the board cotton should be removed.

At the four corners of the door and window, after the standard Bead Plaster is applied, a 200mmx300mm standard Profile Pvc is added to the four corners of the door and window, placed at a 90-degree angle with the bisector of the window angle, and pasted on the outermost side for reinforcement; a 200mm long Profile Pvc with a width suitable for the window width is added to the inner corner and pasted on the outermost side.

Below the first window sill, in order to avoid damage caused by impact, the reinforced PBead Drywall should be installed first, and then the standard Profile Pvc should be installed. The reinforced Bead Drywall of the Profile Pvc manufacturer should be connected. The protective layer cannot be exposed to rain within 4 hours after construction. After the protective layer is finally set, it should be sprayed with water for maintenance in time, and it should not be less than 48 hours when the night average temperature is higher than 15℃, and it should not be less than 72 hours when it is lower than 15℃.