How to make fiber glass mesh more solid?

As a new type of wall anti-cracking and thermal insulation material, Fiber Glass mesh has been used by many builders and home decoration. Thanks to the benefits of Fiber Glass, Fiber Glass has become a must-use building material. How can Fiber Glass be more firmly protected on the wall to protect the house that will be used for many years?

To make the Fiber Glass more solid, you need to pay attention to many aspects during wall construction. The following editor provides you with several precautions for your reference.

1. The Fiber Glass should be cut in a clean and flat place, and the material should be cut accurately. The cut Fiber Glass must be rolled up, and folding and stepping are not allowed. Make a reinforcement layer at the corner of the building, and the reinforcement layer should be attached to the innermost side, 150mm on each side. When applying the first coat of polymer mortar, the EPS board surface should be kept dry and harmful substances or impurities in the board cotton should be removed.

2. A dedicated person is responsible for preparing polymer mortar to ensure the mixing quality. Stir the binder with a stirrer or other tools to avoid separation of the binder, and stir moderately to avoid quality problems.

3. At the four corners of the doors and windows, after the standard fiber glass mesh is applied, the standard fiber glass mesh is added to the four corners of the doors and windows, placed at a 90-degree angle to the bisector of the window angle, and attached to the outermost side for reinforcement; a 200mm long fiber glass mesh with a width suitable for the standard width of the window wing is added to the inner corner and attached to the outermost side. Below the first window sill, in order to prevent damage caused by impact, the reinforced Fiber Glass should be placed first, and then the standard Fiber Glass should be placed. The reinforced Fiber Glass should be connected.

4. After the final setting of the protective layer, it should be sprayed with water for maintenance in time. When the average day and night temperature is higher than 15℃, it shall not be less than 48 hours, and when it is lower than 15℃, it shall not be less than 72 hours. The protective layer cannot be exposed to rain within 4 hours after construction.